Belling 60T Wartungshandbuch Seite 24

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 23
22
Connect to the gas supply
The inlet to the cooker is
1
2 BSP
internal situated at the rear right corner.
Fit the bayonet connection. This should
be located so as to ensure the flexible
connector hose does not kink.
Under no circumstances should the flex-
ible connector be allowed to come into
contact with the vertical oven flue tubes
on the rear of the appliance.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Natural Gas - Flexible connections
should comply with BS 669. Parts of
the appliance likely to come into
contact with a flexible connector have
a temperature rise of less than 70˚C.
After installation, make sure all
connections are gas sound.
Commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector
Grill - Open the grill door, push the
control knob in and turn to the
FULL ON
position. Wait a second before press-
ing the ignition switch or holding a
lighted match or taper to the burner.
Hold the control knob in for 15 sec-
onds. Do not hold the control knob in
for longer that 15 seconds. If the burn-
er fails to light within this time, release
the control knob and wait one minute
before attempting further ignition..
Hob - Turn the control knob to the FULL
ON position, wait a second before
pressing the ignition switch or holding
a lighted match or taper to the burner.
Hold the control knob in for 15 sec-
onds. Do not hold the control knob in
for longer that 15 seconds. If the burn-
er fails to light within this time, release
the control knob and wait one minute
before attempting further ignition.
Oven - Open the oven door. Push in
and turn the control knob to the full on
position (gas mark 9). Hold the control
knob in and operate the ignition
button.Hold the control knob in for 15
seconds. Do not hold the control knob
in for longer that 15 seconds. If the
burner fails to light within this time,
release the control knob and wait one
minute before attempting further igni-
tion.
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to operate
the cooker and give them this
handbook. Thank you.
Installation Instructions
Seitenansicht 23
1 2 ... 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare