Belling IH60RXL Wartungshandbuch PDF herunterladen (Seite 21)

Installation Instructions

Installation advice - cabinetry

Dealing with sides, cross-rails and back-panels

in cabinetry

Depending on the cabinets, the worktop thickness and

the hob positioning, it is possible for the hob base

and/or the clamp brackets to interfere with parts of

the cabinet. These can be dealt with as follows:

Cabinet sides

If the hob is to be installed across the top of two cabi-

net housing units, then the base of the hob may inter-

fere with the sides of these units. It will be necessary

to cut away the top of the unit sides locally to clear

the hob and/or the clamp brackets.

Cross-rails

1. Interference with hob base

If there are any cross-rails which obstruct the hob

base by running across the worktop cutout, they

can simply be removed or locally cut-away to allow

the hob to be installed, depending on the particu-

lar installation. Any modifications must ensure

that the strength of the cabinet is maintained.

2. Interference with clamp brackets

If there are any cross-rails which prevent the

clamps from being positioned on the front or rear

edges of the hob, then they can be removed or

locally cut-away around the brackets to allow the

brackets to be installed. Any modifications must

ensure that the strength of the cabinet is main-

tained.

Back-panel

If the cabinet has a back-panel which prevents the

clamps from being positioned on the rear edge of the

hob, then this panel can be completely removed or

locally cut-away to allow the brackets to be installed.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Belling IH60RXL Wartungshandbuch Seite 21